Şimdi Ara

Ps3 çift gösteriyor

Daha Fazla
Bu Konudaki Kullanıcılar: Daha Az
2 Misafir - 2 Masaüstü
5 sn
6
Cevap
0
Favori
457
Tıklama
Daha Fazla
İstatistik
  • Konu İstatistikleri Yükleniyor
0 oy
Öne Çıkar
Sayfa: 1
Giriş
Mesaj
  • Ps3 le tv arasında uyuşmazlık sorunu yaşıyorum.

    Tv kdf 50 inch sony, 50 hz destekliyor.

    Ps3 60 hz bilindiği üzere , görüntü gölgeli şekilde çıkıyo

    sorulmadan söyliyim
    i) ps3 yurtdışı usa den alınma
    ii) oyunlarla alakası olamaz oyun oynamıyorken de gölgeli
    iii) hdmi kabloyla bağlantıyı sağlıyorum



  • Bak bakalim etrafta bos bira kutusu gorebilecek misin :)



    < Bu mesaj bu kişi tarafından değiştirildi Kasatka -- 14 Kasım 2009; 15:52:09 >
  • biraz erken dilmi ;)
  • Neyse dh nin üstün yardımlarına gerek kalmadan olayı çözdük..

    Aşağıda çözümü veriyorum, bravia model sonyler için geçerli bu çözüm

    To access the hidden menu, turn your TV into standby mode and press the following.

    [i+] (little button with i+ in a kind of tv icon)

    Press Channel 5

    Press Volume UP

    Press Analogue (its the middle button on the top of the remote)

    Once you have pressed these buttons in succession your tv should boot up onto a new screen with large green letters. This shows that its so far so good and we can now proceed to the more complicated settings.

    Press the menu button (At the bottom of the remote)

    You will then be presented with a new menu down the left hand side of the screen.

    Use the direction buttons on the remote and move down to the LCD Drivers option and press right to enter the menu.

    You are now presented with a new menu / option screen.

    There are three settings that need changing and all relate to the synchronizing of the horizontal RGB (Red,Green,Blue) and simply shifts the colours back into position.

    Move down to “S H POS REG R” - The settings should currently be set at 10. Press right to change the value to 11. Do the same for S H POS REG G and then move down to the bottom of the screen keep pressing down until you see S H POS REG B and change the value to 11 then press the menu button to back out of the menu before pressing standby.

    Now simply press standby again to start up your TV and your problem should be sorted.




  • Dostum ben görseydim sorunu cevaplardım :) Aynı konundan iki yıl öncede ben muzdariptim. Çözümü gayet basit, dediğin gibi sistem menüsüne girip üç tane deüeri değiştiriyoruz oldu bitti
  • eyvallah..
    kendin arıyıp bulması da ayrı güzel ama
  • 
Sayfa: 1
- x
Bildirim
mesajınız kopyalandı (ctrl+v) yapıştırmak istediğiniz yere yapıştırabilirsiniz.